LM1510 Servo Drive Label Applicator
US
ER’S MANUAL
Page
63
Made in the U.S.A.
© 2019 LabelMill
11/01/2019 Model LM1510
FAULT CODES
DISPLAYED FAULT
DESCRIPTION
CORRECTIVE ACTION
Memory Checksum
Data lost in battery SRAM
Consult factory or service provider
Missing Label
Too many labels missing on web
Check label stock
Following Error
Servo motor stalled
(Load too high for motor)
Check acceleration value
Check for proper label webbing
Lower speed
Head Up Fault
Head up limit switch on tamp did not
trigger
Check for proper adjustment of
head up limit switch
Check air to system
Head Down Fault
Head up limit switch failed to switch
during the tamp cycle
Tamp duration too small
Faulty limit switch
Check air to system
Label Not Found
Label not sensed in auto set up
Check label stock
Check label sensor
Retry auto set up
Label Present Fault / Feed Error
Label present sensor failed to
Detect label
Feed error option enable without
hardware attached.
Label present sensor faulty or miss
adjusted
Emergency-Stop
E-
Stop on Labeler is “ON”
Remove the E-Stop Condition
Motor Temp Exceeded
Servo Motor Over Heated
Cool Servo Motor / Cycle Power
Servo Drive Fault
Servo motor stalled
(Load too high for motor)
Check acceleration value
Check for proper label webbing
Lower speed
Broken Web Fault
Label Web Broken
Label Sensor Blocked
Labeler feed 2X Programmed Label
Length and Failed to Detect a Label
Re-Web Labeler
Check Label Sensor
Turn Off Broken Web Feature
Incorrect Value Entered in Label
Length in Control
Waiting For Servo
Servo Drive is Powering Up
Wait for Servo Drive
Auto Setup Failed
Label present sensor failed to
Detect label
Check For Proper Webbing of
Labeler & Re-initiate Feature
5-3
