LabelMill LM1510, Руководство по эксплуатации

Страница: 52 / 65

LM1510 Servo Drive Label Applicator
USER’S MANUAL
Page
52
Made in the U.S.A.
© 2019 LabelMill 11/01/2019 Model LM1510

WHEN NOT UTILIZING A ENCODER
Product delay is similar to trigger distance in that it is used to electronically move the placement of the
FIRST label
on the product. Product delay will move the label placement in time (00.000). Because the product delay feature
utilizes time, the speed of the product MUST be constant and consistent. This section will explain how to apply
more than one label to a single product with a single start signal. MULTIPLE FEED will allow you to select how
many labels to be applied. Note that when the start signal “goes false” this feature is reset.
1. Set basic applicator up first, refer to quick setup
2. Ensure that applicator is operating properly before starting this procedure.
3. This feature requires the use of an encoder. The appropriate encoder features should be setup prior to this
feature.
4.
Set ENCODER to “OFF”.
5.
Set CONVEYOR LOCK to “OFF” if in ASYNCHRONOUS operation.
6. If in SYNCHRONOUS operation PRODUCT DELAY WILL NOT WORK
7. Set Product delay to 00.000
8. Start system and apply label at the desired speed.
9. Check the placement of the label on the product.
10. Measure the OFFSET of the label placement. Note: A label CAN NOT be advanced on the product ONLY
moved “back” since the applicator can only delay the product signal.
11. Apply a small delay to the product delay or if too great, it may be necessary to physically move the product
switch. Keep product delays to a minimum for best results.
12. Operate system again and measure offset.
13. Apply a small delay to the product delay or reduce if too much.
14. Test again, repeat if necessary until label is in proper registration.
15. Go to
MULTIPLE FEED in menu #1 and set the number of labels to be applied to the product.
16. Set the Distance between each label entering a time (0.000) into
“INTERVAL DELAY”
17. Test the placement of the labels and adjust as necessary. Note: The spacing between each label will be
equal. With this feature the space between labels can not be set individually.
18. Note: TRAILING EDGE TRIGGER will NOT work with this feature!
19. Note: Product speed fluctuations can effect label placement.
20. Turn back on any options that may have been disabled for setup of this particular feature.
4-32