GENERAL SAFETY WARNINGS
Carefully read this instruction manual for the safe installation and operation of the automatic
door. Improper installation and incorrect use of the product could cause serious injury.
Keep the instruction manual for future reference.
The installer must provide all the information about operation and provide the system user with the user manual delivered
with the product.
MEANING OF THE SYMBOLS USED IN THESE INSTRUCTIONS
DANGER: Indication of dangerous situations that could cause material damage and personal injury.
WARNING: Identifies the procedures that must be understood and followed to prevent product damage or malfunctions.
NOTE: To point out and place attention on important information.
GENERAL SAFETY OBLIGATIONS
The mechanical and electric installation must be performed by specialised personnel in accordance with current directives
and regulations.
The installer must make sure that the structure to be automated is stable and robust and if necessary, make it this way by
making structural modifications.
Keep product and packaging materials out of children's reach, as they might be a source of
danger. Do not let the children stay or play within the range of the door.
This product was designed and built exclusively for the purpose described in this documentation. Any other use that is not
specifically indicated could adversely impact the condition of the product and the safety of people.
iSee Access Solutions accepts no responsibility for incorrect product installation and usage, as well as for any damages
caused by changes made without its prior consent.
iSee Access Solutions is not responsible for the construction of the fixtures to be motorised.
The IP67 degree of protection requires that the operator is installed exactly as per the installation instructions.
This product cannot be installed in explosive environments or atmospheres, or in the presence of flammable gases or
fumes.
Make sure that the characteristics of the electric distribution network are compatible with the technical data indicated in this
manual and that upstream of the system there is a double pole isolation switch with an opening distance of the contacts of
at least 3mm and a 30mA residual current device.
Ensure the electric circuit is fully earthed.
The automatic door must be checked, started up and tested by an iSee Access Solutions trained engineer and
commissioned to EN16005.
A risk assessment must be conducted for every automation as required by the Machine
Directive. Disconnect the power supply before working on the automation and before
opening the cover of the control panel.
Maintenance is of fundamental importance for the proper operation and safety of the automation. Check the efficiency of all
parts every six months.
Use only original spare parts for maintenance and when replacing product components.
Cleaning operations must be performed with the power supply disconnected, using a damp cloth. Do not deposit or let
water or other liquids penetrate into the floor operator or the accessories that are part of the system.
It is recommended to take out a maintenance contract.
Risk assessment
The automatic swinging doors must be designed and installed in a way to protect users against the risk and danger of
crushing, impact and shearing between the door and adjacent parts near the door.
The person responsible for starting-up the automation must perform a risk assessment based on the place of installation
and the type of users that could use the automatic door.
The
Vista
SMP underfloor operator, as required by EN16005 standard, must be equipped by protection devices (sensors) in
accordance with EN12978
A = Main closing edge
B = Secondary closing edge
C = Opposite closing edge
The dangers of crushing and shearing related to the secondary closing edge must be prevented
either structurally or by supplementary protective measures (25mm rubber profile, rollerblind FG).
Any residual risks must be properly signalled.
4
Содержание Vista SMP
Страница 56: ...VISTA SMP Made in UK ...
