La San Marco 85 Flexa E series, Использование и обслуживание

Страница: 19 / 96

16
ENGLISH
1. Introduction
Before using the machine, carefully read all of the instructions contained in this machine.
1.1 Using the manual
This manual contains all information required for the installation, use and maintenance of the
coffee machine.
1.2 Warnings
• Do not operate the machine or carry out routine maintenance before reading this manual.
• This machine is designed and built for serving espresso coffee, hot water (for the pre-
paration of beverages and infusions) and steam (used to heat liquids). The use of the
machine for any other than its intended purposes is considered to be improper and
unauthorized. The manufacturer declines any liability for damage resulting from the
improper use of the machine.
• The user must be a responsible adult, who is expected to comply with local safety rules
and accepted common sense procedures.
• It is absolutely prohibited to operate the machine with the fixed and/or mobile guards
removed or with the safety devices bypassed. The panels covering the machine must
not be removed, as the machine contains live parts (there is the risk of electric shock).
• Do not install the espresso coffee machine in places where cleaning is to be carried out
with jets of water. Do not immerge the unit in water.
• Strict compliance with the routine maintenance instructions of this manual is required
for a safe and efficient operation of the appliance.
• In the event of problems or breakage of any component of the espresso coffee machi-
ne, contact an authorized service centre and insist on original spare parts.
• If the power cord is damaged, it must be replaced by the manufacturer, the manufactu-
rer’s technical service or a similarly qualified person so as to prevent any sort of risk.
• The user must never perform any operation for which he/she is unauthorized or lacks
training. Contact the manufacturer for any information, spare parts or accessories.
• The machine is supplied with two boilers without water, to prevent the exposure of the
machine to temperatures below 0°C from irreparably damaging it. After use, if the ma-
chine is to be stored in locations with temperatures at or below 0°C, the coffee boiler
must be emptied as follows:
1. Lift the water intake tube of the coffee circuit located in the tank.
2. Remove the filter cup from the dispensing assembly.
3. Press key A on the push button panel.
4. When you see that water is no longer coming out of the dispensing assembly, press
key A again.
5. Place the water intake tube back in the tank.
6. The machine is now ready to be stored in cold locations.