(P/N) 754.118 Rev B 02/12 • © copyright 2006-2012
Kaba Mas LLC
Page 2 of 2
•
Valid Combination Entry - Double signal after valid six (6) digit combination
is entered.
•
Invalid Combination Entry - Triple signal indicates old combination is still valid.
BATTERY LOW WARNING
• Repeated LED flashing and beeping during an opening indicates that the battery
is low and needs immediate replacement.
• Uses one (1) 9-Volt alkaline battery only. (Example: Duracell™ or Eveready™
alkaline batteries.) It is recommended that batteries be replaced at least once
a year.
If battery is depleted and will not allow lock to open, follow instructions below.
Lock contains a non-volatile memory; even with the batteries removed the lock
will retain all programming.
CHANGING YOUR BATTERY
1. Remove black plastic battery compartment
cover (located at the bottom of the keypad)
by gently pulling downward on its handle.
2. Allow the battery and its attached leads to
drop down and out of the battery
compartment. If it does not drop, gently pull
on the battery until it does.
3. Remove the connector by unsnapping
it from the two terminals on the top of
the battery.
CAUTION! Hold onto battery terminal
connector to avoid pulling the wires out of
housing.
4. Press and hold the zero(0) key for ten (10)
seconds before installing a new battery.
5. Connect a new 9-Volt alkaline battery to the
battery clip.
6. Push the battery and the leads completely
into the battery compartment.
7. Install the battery cover by placing one side
of the cover in position and then pressing
the other side into position with your finger.
Mounting Instructions available at www.kaba-mas.com.
