17
2012/3/8Ver1.4+Ver1.1
The scrolling text
『
AVERAGE SPEED =
』
, then
『
MLH= 0.0
』
The scrolling text
『
CALORIES BURNT =
』
, then
『
KCAL= 0.0
』
The scrolling text
『
AVERAGE WATTS =
』
, then
『
WATTS= 0.0
』
The scrolling text
『
AVERAGE METS =
』
, then
『
METS= 0.0
』
5-9.
Introduction of HR CONTROL mode: pre-set the heart rate control mode as 50W.
When t signal of the heat rate is detected, console will judge the heat rate value once
every 10 seconds.
5-9-1.
During the exercise, the program will compare the actual value of heart rate
with the target value of heart rate. The following is the way to judge the value of
heart rate:
When the actual heart rate value
≦
set heart rate value 15, WATT will
automatically increase 20 with maximum as 400 WATT.
When the actual heart rate value
≦
set heart rate value 5, WATT will
automatically increase 10 with maximum as 400 WATT.
When the actual heart rate value set heart rate value 5, WATT will
≧
automatically decrease 10 with minimum as 50 WATT.
When the actual heart rate value set heart rate value 15, WATT will
≧
automatically decrease 20 with minimum as 50 WATT.
When the actual heart rate value set heart rate value 30, WATT will
≧
automatically decrease to 50WATT. While the actual heart rate value
≦
set
heart rate value 5, the program will continue performing.
5-9-2.
During exercise, if heart rate signal is not detected, the figure will display “NO
PULSE”. The console will enter the PAUSE mode if no signal is detected after
60 seconds.
5-9-3.
When PRM is less than 40, Dot Matrix will display
『
RPM
↑
』
and the console
will enter PAUSE mode after 5 seconds.
5-9-4.
HR CONTROL mode can be operated only with wireless heart rate.
5-9-5.
During the program, Dot Matrix will show the following: the pre-set is Level 1.
Up and Down keys cannot be used.
6.
WATT Mode
：
WATT CONTROL Mode
6-1.
Under Start/Ready status, press WATT and the Dot Matrix will display
『
WATT
』
, the
scrolling text will display PRESS ENTER TO BEGIN PROFILE.
』
from right to left.
6-2.
Press ENTER key to change Target WATT, the scrolling text will display
『
ENTER
WATT <25-400>
』
. You can set the value of Target WATT by the number keys 0~9
and the scrolling text will display
『
WATTS= xxx
』
, the input value will be
blinking. When you press 0-9 to set values, you should set 2 or 3 digits (range: from
25 to 400).. After setting, press ENTER to confirm.
6-3.
You can press ENTER to set time, the scrolling text will display
『
ENTER TIME <10
