5
Battery
Cover
DETAILED SET-UP GUIDE
Important: Insert batteries into the sensor first, then into the alarm clock. Do not
press any buttons until remote temperature is displayed.
I.
BATTERY INSTALLATION
A.
Remote Temperature Sensor
1.
Remove the battery cover.
2.
Observing the correct polarity, install 2 AA
batteries.
3.
The batteries will fit tightly to avoid start-up
problems make sure that they do not spring free
during installation.
4.
Replace the battery cover.
B.
Projection Alarm
1.
Remove the battery cover.
2.
Observe the correct polarity,
and install 3 AA batteries.
3.
In addition to, or instead of
inserting batteries, the AC
adapter can be used. Simply
insert the adapter into the
receptacle on the underneath
of the alarm clock and then plug the adapter into the wall socket.
4.
Replace the battery cover.
The projector will activate and remain on if the alarm clock is plugged in. If
only batteries are used, the projector will only be activated when a button is
pressed. The projection is a red light, not harmful under normal usage, although
care should be taken to not look directly into the light.
Note: After the batteries have been installed a tone will sound, and the LCD
(Liquid Crystal Display) will activate. The indoor temperature and the remote
temperature will be displayed (within three minutes). Also, the time will appear
as “-:--”. The WWVB search is automatically initiated, and a tower icon
appears and flashes with the time colon (no tower icon will appear if the WWVB
is too weak to be detected, and the time display will remain on “-:--”). While
the WWVB search is being conducted various numbers will appear in the time
display. After 10 minutes, the projection alarm will either display the WWVB
time or discontinue the search if the time is not found. If the search is cancelled
“-:--” will remain in the time LCD. The projection alarm will conduct a WWVB
search every hour until the first signal is found. Once the WWVB time is found,
