6
III.
PROGRAM MODE
To enter the Program Mode hold down the “MODE/MIN” button for 3 seconds, until the time
flashes in the top of the display. The Program Mode Guide is laid out in a manner that allows
you to program each function separately, or you can follow the instructions entirely to program
the projection alarm. Complete programming is usually done for the initial set-up, and will
require you to skip step 1 and 2 of programming sections D and E. To exit the setting mode
simply wait approximately 10 seconds for the projection alarm to automatically return to normal
operation.
A. PROGRAMMING
SEQUENCE
1.
Manual Time Display
2.
Time Zone Setting
3.
Daylight Saving Time On/Off
B. FUNCTION
BUTTONS
There are 3 function buttons located on the front of the projection alarm and one on the top.
The function buttons are labeled:
AL/HOUR
, light direction icon,
MODE/MIN
, and
SNOOZE
(the top bar).
C. MANUAL
TIME
SETTING
1.
Hold down the “
MODE/MIN”
button for 3 seconds, the time will flash in the Time LCD.
2.
Press and release the
“AL/HOUR”
button to advance the hours and press and release
the
“MODE/MIN”
button to advance the minutes.
NOTE: “A.M.” or “P.M.” will be displayed to the left of the time to help identify the time.
3.
Press and release the “
SNOOZE”
button to confirm the time setting and to advance to
DST (Daylight Saving Time) setting.
D.
TIME ZONE SETTING
1.
Hold down the “
MODE/MIN”
button for 3 seconds, the time will flash in the Time LCD.
2.
Press and release the
“SNOOZE”
button to advance to the time zone selection.
3.
In the indoor temperature/humidity section of the LCD the time zone will flash.
Mode Button (toggles between
indoor temp/hum and alarm
time. Also adjusts minutes in
time setting mode
Alarm Button (also adjusts
the hours in time setting
mode)
Display Direction
