11
V.
MOUNTING THE REMOTE TEMPERATURE SENSOR
The remote temperature sensor can be mounted in two ways:
1) Using screws
2) Using the adhesive tape.
A.
MOUNTING WITH SCREWS
1.
Remove the mounting bracket from the remote temperature sensor. The bracket
should snap off easily.
2.
Place the mounting bracket over the desired location. Through the three screw holes
of the bracket, mark the mounting surface with a pencil.
3.
Where marked, start the screw holes into the mounting surface.
4.
Screw mounting bracket onto the mounting surface. Ensure that the screws are flush
with the bracket.
5.
Snap the remote temperature sensor onto the mounted bracket.
B.
MOUNTING WITH ADHESIVE TAPE
1.
With a nonabrasive solution, clean and dry the back of the mounting bracket and the
mounting surface to ensure a secure hold. The mounting surface should be smooth
and flat.
2.
Remove the protective strip from one side of the tape. Adhere the tape to the
designated area on the back of the mounting bracket. Remove the protective strip
from the other side of the tape. Position the remote temperature sensor in the desired
location, ensuring that the projection alarm clock can receive the signal.
VI.
MAINTENANCE & CARE
A.
Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the
units.
B.
Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents—
they may mark and damage the displays and casings.
C.
Do not submerge in water.
D.
Immediately remove all low powered batteries to avoid leakage and damage.
E.
Replace with new batteries only, and of recommended size.
F.
Opening the casings invalidates the warranty. Do not try to repair the units. Contact
La Crosse Technology for Repairs.
