5
1.
Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the
battery cover, then push up and pull out on the battery cover.
2.
Observe the correct polarity, and install 3 AA batteries.
3.
Replace the battery cover.
Note:
Immediately after the batteries have been installed, the LCD (Liquid Crystal Display) will flash. Within 15
seconds the indoor temperature, indoor relative humidity, and the weather icons (sun and clouds) will be displayed.
If not, remove batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes,
remove batteries from both units, wait 30 seconds, and reinstall making sure to install batteries into the remote
temperature sensor first. The time will show -:-- and start searching for the WWVB signal. If it successfully receives
the time signal (usually at night), it will display the correct time (default time-zone is Eastern). You will need to
adjust the time zone to match your local time.
PROGRAM MODE
Programming Note:
If 30 seconds are allowed to pass, or the
WIND/SNZ
button is pressed during the programming mode, the
unit will confirm/set the last information entered—the display will stop flashing and return to normal time-date readings. If you
don’t leave the program mode during the programming of sections IV through XI, you can advance to step 4 of the next program
setting. If you do leave the program setting (or want to program a specific setting) follow each instructional step to program that
setting.
I.
PROGRAMMING SEQUENCE AND DEFAULT SETTINGS
The programming sequence and default (factory) settings are as follows:
LCD Contrast
5
Time Zone
-5 (Eastern)
Daylight Saving Time
ON
Radio-controlled time reception
ON
12/24-hour time
12
Time – Hour
12
Time – Minute
:00
Year 2003
Month 1
Day 1
Snooze 10
minutes
Temperature Format
°
F
Forecast Sensitivity
2
II.
FUNCTION KEYS
The function keys are located on the front of the unit directly below the LCD (Liquid Crystal Display).
