15
•
wall
mounting
FOLDOUT TABLE STAND
The foldout table stand legs are located on the backside, at the lower corners, just
below the battery cover. The hinges are towards the edges of the atomic clock, and
the ends (with no hinge) need to be folded out towards the edge. Once the foldout
table stands are extended, place the atomic clock in an appropriate location.
WALL MOUNTING
1) Using a straight edge, horizontally space at 2-3/4 of an inch (70 mm) three
screw positions on a wall.
2) Install three mounting screws (not included) into a wall —leaving
approximately 3/16 of an inch (5mm) extended from the wall.
3) Place the atomic clock onto the screws, using the hanging holes on the
backside. Gently pull the atomic clock down to lock the screws into place.
Note:
Always ensure that the atomic clock locks onto the screws before releasing.
POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER
The outdoor temperature transmitter can be mounted in two ways:
•
with the use of screws
•
using the adhesive tape.
MOUNTING WITH SCREWS
1)
Remove the mounting bracket from the outdoor temperature
transmitter.
2)
Place the mounting bracket over the desired location. Through the
three screw holes of the bracket, mark the mounting surface with a
pencil.