57
Installation Guide - "Château" Range G4
08NOTINSTALG4/EN-1
Starting with the cooktop
IGNITION – ADJUSTMENTS
· Low setting:
this is achieved by rotating the knob fully to the left or to the bottom.
· Shutoff:
bring the knob back to its vertical position by rotating it to the right.
In case the burner flame is accidentally turned off, close the burner control knob and do
not turn on the burner for at least one minute.
1.2. Hotplate or lava rock grill with electric ignition
Ignition identical to that for gas burners.
1.3. Ceramic Hob (2 zones)
To heat a ceramic plate with a single burner (diameter: 145 mm), turn the knob towards
the right or towards the left to the desired position:
- 1 corresponds to the lowest position,
- 6 corresponds to the highest position,
- 0 corresponds to the shutoff position.
To heat the central burner of a ceramic plate with a double burner and
2 zones (diameter: 180/110 mm), you just have to rotate the double-
circuit simmerstat clockwise.
To ignite the 2 (outer and central) burners, turn the knob towards the
right to the sign
o
o
(see the figure shown opposite) until you hear a
click from the microswitch that will light the peripheral element.
The two burners reach the maximum temperature in this position.
You can then set the temperature of the double burner by turning the
control knob to any position between 6 and 1.
Note: it is impossible to only ignite the outer burner.
The vitroceramic plates have 3 indicator lights: one at the bottom left
- these come on when a hob control is turned on and two indicator
lights of residual heat (one for each cooking areas) in the bottom
right.
As long as the symbol of residual heat is on, do not touch the cooking areas and
do not place anything sensitive to heat on the ceramic glass.
Gas lava rock grill
Gas hotplate
(small)
Gas hotplate
(large)
