4
Installation Guide - “Château” Range G4
08NOTINSTALG4/EN-1
WARNING
WARNING
W
ARNING
T
his appliance must be installed by a qualified professional in
accordance with the current regulations in the country where the
appliance is installed and must only be used in a well ventilated
area. Read the guides before installing and using this appliance.
Appliance categories (see pt. 1.2, page 46 “Installation”):
- Class 1: Free-standing cooking appliance not normally in direct contact with the kitchen
units or the surrounding walls.
-Class 2: Cooking appliance that can be integrated between two kitchen units, whose walls
can be in direct contact with the surrounding units. This type of appliance can be in
contact with only one kitchen unit during installation.
- Class 2 / Sub-Class 1: Class 2 appliance that can be free-standing or installed so that the
side panels are accessible.
Before installing the appliance, ensure that the local gas supply conditions (gas
type and pressure) and the adjustment of the appliance are compatible.
The adjustment conditions for this appliance are indicated on the label at the
back of the hob and on the test certificate.
This appliance is not intended to be connected to a ventilation system or a ventilation shaft
for combustion products. It should be installed and connected in accordance with the
current regulations, and special attention should be paid to the applicable ventilation
regulations.
The use of a gas cooking appliance results in the production of heat and moisture in the
room where it is installed.
Ensure that the room is well ventilated:
keep natural
ventilation holes open and install a mechanical ventilation device (mechanical extractor
hood).
Prolonged or intensive use of the appliance may call for additional ventilation, e.g. by
opening a window, or for more effective ventilation, by increasing the power of the
mechanical ventilation system installed.
When you first use your cooker it may give off a slight odour.
This should stop after a little use.
The parts that are protected by the manufacturer must not be manipulated by the installer
or the user.
