66
Installation Guide - "Château" Range G4
08NOTINSTALG4/EN-1
Access is gained to the oven injector either from the back of the cooker or from the front
by removing the drawer. It is easier to change the injector by accessing it from the rear.
Once you have changed the injectors, it is a good idea to adjust the low settings for the
hob burners (see Section 5).
Once the appliance has been adapted to a different type of gas or to a pressure
other than those for which it was previously set, the new settings will have to be
indicated in place of the previous settings, and a new gas information label will
be supplied with the new injectors.
Any sealing will have to be replaced.
Only the low settings for the gas hob burners, the hotplate and the lava rock grill can be
adjusted with the following procedure:
u
Ignite the burner to be adjusted, and then turn
the control knob to the "low" position.
v
Dismantle the control knobs by unscrewing from
each knob the screw holding it in place.
w
Turn the split screw on the body of the gas tap
towards the left to increase the flow or towards
the right to reduce it.
For Butane and Propane gas, turn the knob fully
to the right.
Make sure
that the resulting flame, at the lowest setting, is sufficiently strong to heat
the thermocouple.
x
Refit the knob to turn the burner off, ensuring that you leave a sufficient gap
between the knobs and the tap cover (the knob, when held down, should not come
into contact with the tap cover).
5. A
DJUSTING THE LOW SETTINGS
IGNITION – ADJUSTMENTS
Injectors. Low setting
Injector
Back of the cooker
Front of the cooker
Injector
