La Castellana GIANGI CC, Руководство по обслуживанию и техническому обслуживанию

Страница: 18 / 136

Manuale d’istruzione Sez.7 All. 9 Rev. 3 del 25.07.2013
18
SELECTING A LOCATION
AIR STOVES
When positioning the stove select the most central point in the desired location in
order to easily and uniformly heat and obtain a sure optimal profit.
Once you have chosen the right location, near a chimney flue, place a floor protector
under the stove (optional) if the floor is made of flammable material such as parquet or
moquette.
TERMOIDRO ( boiler stove)
A boiler stove requires a wide space, as it may get hot due to stove’s warmth, while all
the rest of the house will be heated through radiators or floor’s heating plant. For the
rest the same principles of normal pellet stoves are valid.
ELECTRICAL WIRING
1.
Electrical wiring of the stove needs a grounded electrical outlet. Before plugging
please ensure the efficiency of outlet.
2. While installing please make sure not to let the cable system contact the stove’s
hot parts. To avoid the danger of short circuits, ensure the cable is not crushed by
the stove.
Note: The stove’s plant is protected by two fuses plugged into the main switch
placed behind the stove.
Always remember to remove voltage from the stove before maintenance and/or
inspection!!
INSTALLATIONS
Installing the stove to the chimney flue
is an important operation which may
compromise the proper functioning of the stove, so it should be always supervised by
a qualified person. We strongly recommend avoiding any operation without complete
knowledge of all necessary instructions.
Precisely calculate the diameter of the flue apart from the diameter of the stove’s
outlet: the right functioning of a pellet stove depends on the efficiency of the chimney
flue.
Before installation please ensure that the internal section and chimney flue’s
height are adequately measured to obtain a proper draft and that this is not
obstructed or incorrectly connected. Regulation of chimney flue for pellet
stoves follows the same rule for flues for fireplaces and wood stoves, so they
have been produced to make use of natural aspiration. Please remember: they
need an aspiration of 10 Pascal, when hot.
Reductions in diameter on the area of pipes connecting to chimney flue are not allowed: in order
to obtain a good burning it is better not to install horizontal segments because they’re subject to
be filled with ash from the subsequent reduction of the section provided. Also it is wise to avoid
excessive use of curves (max.2): they should be fixed permanently to get maximum security and
lower pressure drop.