11
1. Tap one retaining cap onto one end of the axle with a
hammer.
2. Slide the wheel onto the axle, making sure the slots
on the wheel are toward retaining cap.
3. Slide the nylon spacer onto axle.
4. Slide the axle through holes in the base assembly
until the nylon spacer butts up against the case.
5. Slide the remaining spacer and wheel onto the axle.
Make sure slots on wheel face are directed towards
end of shaft.
6. Tap the remaining retaining cap onto the end of the
shaft until it is securely attached.
7. Snap hub caps into wheel slots.
FIG. 1.
1. Placing cardboard or other material under the hinged
burner access panel to prevent scratching, tip the
heater back so the louvered air inlet panel is facing
up.
2. Mount the support leg to the underside of the base
using four 12.7 mm bolts and lock washers provided.
FIG. 2
WHEEL ASSEMBLY
MODEL TS170
LEG ASSEMBLY
MODEL TS170
Mount the hose hanger to the back of the heater as shown.
Use the 19 mm bolts and 6 mm washers provided. Tighten
both bolts securely.
FIG. 3
HOSE HANGER
AXLE
HUB CAP
WHEEL
NYLON
SPACER
RETAINING
CAP
NUT, CAGE
BOLT
LEG
HEATER BASE
LOCK WASHER
CAGE NUT
HOSE HANGER
BOLT
FLAT WASHER
HEATER CASE SIDE