L.B. White CP125AK, Инструкция и руководство пользователя

Страница: 9 / 52

Front Handle
Rear Handle
Axle
Wheel Support Frame
CP125AK / CP170AK / CP210AK
Figure 4 – Component Identification
Model CP125AK CP170AK CP210AK
Wheel Support Frame Yes Yes Yes
Wheels Yes Yes Yes
Cap-Wheel Yes Yes Yes
Front-Handle Yes Yes Yes
Rear-Handle Yes Yes Yes
Axle Yes Yes Yes
Cord Wrap Yes Yes Yes
Hardware Kit Yes Yes Yes
Installation and Assembly Instructions
ASSEMBLY
TOOLS REQUIRED
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
- Long nose pliers.
1.
Slide axle through wheel support frame. Install wheel bushings and wheels on axle.
NOTE: When installing wheels, tube valve should face out from support frame (Figure 3).
2. Place flat washers and cotter pin on axle ends and bend cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers and put wheel cap in flat washers end.
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame as shown in
Figure 4 and attach and nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
7. Insert screws through cord wrap, handles as shown in Figure 4 and attach nut finger tight after each screw is
inserted.
8. After all screws are inserted, tighten nuts firmly.
WARNING
Fire or explosion hazard!
■
Do not operate heater without support frame fully
assembled to tank.
4 8
Wheel Caps
Washers
Cotter Pins
Flange Screws Nuts
Bushings
Screws L & S
Wheels
Washers
Wheel Caps