L.B. White AD060, Инструкция и руководство пользователя

Страница: 8 / 80

Guardian Brood Heaters
www.lbwhite.com
Owner’s Manual • Guardian
8
10. Check for gas leaks and proper function upon
brood heater installation, before building repopu-
lation or when relocating.
11. This brood heater should be inspected for proper
RSHUDWLRQE\DTXDOL¿HGVHUYLFHSHUVRQEHIRUH
building repopulation and at least annually.
12. Always turn off the gas supply if the brood heater
is not going to be used.
13. This brood heater is wired for a three-wire elec-
trical system. There is a hot lead, neutral lead
and ground lead. The brood heater may or may
not incorporate a plug in the power cord to the
brood heater and the plug may or may not incor-
porate a pin for the ground wire. In any case, the
brood heater must be properly connected into
a grounded electrical supply using the ground
lead in the power cord. Failure to use a properly
grounded electrical supply can result in electrical
shock, personal injury or death.
14. Direct ignition brood heaters will make up to
three trials for ignition. If ignition is not achieved,
the control system will lock out the gas control
valve. If gas is smelled after system lock out
has occurred, immediately close all fuel supply
valves. Do not relight until you are sure that all
gas that may have accumulated has cleared
away. In any event, do not relight for at least 5
minutes.
15. In a hanging type installation, rigid pipe or
copper tubing coupled directly to the brood
heater may cause gas leaks during movement,
and therefore must not be used. Use only gas
hose assemblies that are rated and approved
for L.P.gas and natural gas in a hanging type of
installation.
16. Installations not using the gas hose supplied with
this appliance must connect dimensionally using
American National Standard Wrought Steel and
Wrought Iron Pipe B36/10-1970. (Aluminum pip-
ing or tubing shall not be used.) Copper tubing
when used for conveying natural gas, shall be
internally tinned or equivalently treated to resist
sulphur.