L.B. White AD060, Инструкция и руководство пользователя

Страница: 12 / 80

Guardian Brood Heaters
www.lbwhite.com
Owner’s Manual • Guardian
12
Assemble the tee, nipples and cap together and
tighten securely. See Fig. 4. The sediment trap
assembly must always be mounted in a vertical
position. Make sure pipe thread compound that is
resistant to both L.P. gas and natural gas is used
in making all connections.
Check all connec-
tions for gas leaks using approved gas
leak detectors.
FIG. 4
Sediment Trap Assembly
Thermostat Installation
(Must be ordered separately)
7R&RQQHFWWKH'LUHFW:LUHG7KHUPRVWDW.LWWRWKH
Control Box on the Brood Heater:
a. Open the control box.
b. Remove the yellow wire connected between the
24 volt output of the transformer and terminal W
of the ignition control.
c. Remove the plastic hole plug at the back or
bottom of the control box. Run the wiring of the
thermostat kit through this hole.
d. Connect the black lead of the thermostat kit to
the 24 volt output terminal of the transformer.
e. Connect the white lead of the thermostat kit to
terminal W of the ignition control.
f. Install the strain relief (supplied on thermostat
cordset) around the cord at the entry hole of the
control box.
g. Close and latch the control box.
h. Start the brood heater and check for proper
operation.
NIPPLE
TEE
NIPPLE
CAP
TO GAS CONTROL
VALVE INLET
Manual Shut-Off Valve,
Hose and Regulator
Assembly
1. Always use approved pipe thread compound
suitable for use with L.P. gas or natural gas on the
threaded connections.
2. Assemble the components together according to
Fig. 5. This view is to show general assembly of
the components only. The regulator must always
be mounted so its vent, regardless of location on
the regulator, is always pointed downward.
3. Tighten all connections securely.
4.
Check all connections for gas leaks
using approved gas leak detectors.
FIG. 5
REGULATOR
NIPPLE
VALVE, MANUAL
SHUT-OFF
GAS HOSE
ADAPTER
SEDIMENT TRAP
TO CONTROL
VALVE INLET
REGULATOR VENT
GAS FLO
W