KIVA SYSTEM
KIVA SB15
m
rigging manual
VERSION 1.1
KIVA-SB15
m
_RM_EN_1.1
w w w . l - a c o u s t i c s . c o m
18
APPENDIX A
INSTALLING THE LAP-TEQ INCLINOMETER
The KIBU-SB is equipped with a laser support plate for the installation of the TEQSAS
®
LAP-TEQ inclinometer. The
LAP-TEQ is a remote control device which is part of the
L-ACOUSTICS
®
TECH TOOLCASE
.
Equipment
Electric screwdriver with torque selector.
T20 Torx
®
bit.
7 mm hex key.
1.
Put the KIBU-SB with its SB15m side up.
2.
Undo the four Torx
®
bolts on the laser support plate.
Use a T20 bit and a 7 mm hex key.
3.
Place the LAP-TEQ on the support plate with its laser lens towards the front laser slit.
Verify nothing obstructs the opening.
4.
Secure the LAP-TEQ with the four Torx
®
bolts and nuts.
Use a T20 bit, a 7 mm hex key and set the torque at 3 N.m / 27 in.lbf.
Calibrating the LAP-TEQ
Refer to the manufacturer instructions in the
L-ACOUSTICS
®
TECH TOOLCASE
. In addition to the
handheld inclinometer available in the TOOLCASE.
An XLR3 cable is needed.
