ESI-500
Pilot’s Guide
2-15
Operation
1. When required the pilot may need to do the following:
• Set the barometric pressure
• Re-align attitude and heading
In-Flight Instructions
In-air alignment should only be performed during
straight and level flight without acceleration.
2. It is recommended that the SynVis mode be disabled using the
Pilot menu for QNE operations above transition altitudes (18,000 ft
in the United States). This is where the barometric altimeter setting
is set to the standard setting of 29.92 inches of mercury, or 1013
hPa or mb. Transition levels may differ from country to country.
NOTE
The Synthetic Vision System and alerting functions use QNH
(Barometric Pressure for Local altimeter Setting) operations.
For QFE (Altitude Above Ground) operation the Synthetic Vision
System must be disabled using the menu.
3. Set the Navigation Mode (VOR/ILS or GPS) as needed, and set
the course setting as needed.
4. During loss of aircraft power the ESI-500 will continue to display
attitude, altitude, airspeed, and heading (MAG-500 installations
only) for approximately 1 hour. External sensor inputs such as
GPS, VHF NAV functions, and ARINC 429 Heading will not be
available unless an independent standby power source is provided
to the sensors.
CAUTION
Содержание ESI-500
