61
Leveling
For correct operation, the refrigerator must be within three degrees
of level in any direction. Continued operation outside of these limits
will result in irreparable damage to the cooling unit in the
refrigerator.
Venting
For an absorption unit to operate fully it must have two vents. One
vent is on the roof or sidewall at the upper end of the refrigerator,
and a second vent is a lower service vent and door at the lower area
of the refrigerator.
Moisture Reduction Heater
Some models have a heater built
into the chassis frame of the
refrigerator, referred to as a
“moisture reduction device”. Its
design is to reduce moisture on
the frame during hot, humid days.
The drawing, at right, shows a
switch on some models. When
using the refrigerator, keep the switch in “NORMAL OPERATION”.
Only use “HIGH HUMIDITY” when observing moisture.
Door Seal
To maintain cooling efficiency the door must seal completely on all
four sides along the door gaskets. Frequent frost build up or reduced
cooling are indicators of air leaks around the doors. Place a strip of
paper the size of a dollar bill between the flange and door gasket.
Close the door and pull the paper out. There should be a light
frictional drag indicating proper seal. Should the paper feel loose,
the gasket is not sealing well. Contact your dealer or service center.
Do not use undue force or jerking action when opening the
refrigerator door. Air temperature differences can cause a par-
tial vacuum within the cabinet requiring a firm but steady
force to open the door. A sudden jerk could cause door dam-
age or personal injury.
CAUTION
!
PDF created with pdfFactory trial version