59
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any gas
control which has been under water.
Before operating the water, check the location of the vent to make
sure it will not be blocked by the opening of any door on the trailer. If
it can be blocked, do not operate the water heater with the door
open.
Lighting Instructions:
1. STOP! Read the safety information provided.
2. Depress and turn valve clockwise to “OFF” position and
temperature indicator to the lowest setting.
3. Turn off all electric power to the appliance.
4. Wait five minutes for gas to clear the area. If you smell gas,
STOP! Follow previous instructions (What To Do If You Smell
Gas). If you do not smell gas, go to the next step.
5. Depress and turn the gas valve counterclockwise to “PILOT”
position, press down and light the pilot, hold down until pilot
remains lit.
6. Depress and turn the gas valve counterclockwise to “ON”
position.
7. If the pilot goes out, repeat steps two through six. On initial start-
up, this may take several times in order to purge the air from the
gas lines.
8. Turn on all electrical power to the appliance if the combination
electric/gas feature is a part of the water heater.
9. Set the temperature dial to desired setting.
10. Test water before bathing or showering.
PILOT FLAME
Temperature
Dial
Gas Valve
PDF created with pdfFactory trial version