55
Operating Instructions
1. Stop! Read Users Information Manual supplied with the furnace.
2. Turn the manual valve (if so equipped) or the valve at the
outside propane tank to the “OFF” position. Do not force.
3. Move the “OFF” lever located at the bottom of the thermostat to
the “ON” position.
4. Set the thermostat above room temperature to begin blower
operation. A slight delay will occur before the blower comes on.
Allow the blower to run for five minutes for the combustion
chamber purge cycle.
5. After five minutes, move the thermostat lever below room
temperature. The blower will remain on. Wait approximately two
minutes for the blower to go off.
6. Open the manual shut-off valve (if so equipped) or the valve at
the outside propane tank. Correct operating characteristics
depend on the valve being positioned fully open. Never attempt
to operate with a valve partially closed. NOTE: This furnace is
equipped with a shut-off switch. With the switch in the “OFF”
position, gas will not flow to the burner, nor will the furnace
operate.
7. Set the thermostat lever to the desired setting. If set above room
temperature, the blower will come on.
NOTE: During initial firing of this furnace, a burn-off of excess paint
and oils remaining from the manufacturing process may cause
"smoking" for five to ten minutes.
To Shut Down:
1. Set thermostat to the “OFF” position by moving the lever on the
bottom of the thermostat to the “OFF” position.
2. Turn the manual shutoff valve (if so equipped) to the “OFF”
position. Do not force.
External Vents.
Always be sure these vents are clear of any objects
like screens, duct tape, etc.
DO NOT operate furnace while vehicle is in motion or being towed.
WARNING
!
Do not install screens over the vents for any reason. Screens will become
restrictions causing unsafe or inefficient operation.
WARNING
!
PDF created with pdfFactory trial version