KZ RV SPORTSMEN, Руководство пользователя

Страница: 86 / 101

79
THERMOSTAT (with out air conditioner)
Upper left side has an on/off switch to engage electrical current for
operation. Same lever will also set temperature as desired.
A third type of thermostat is used only when air conditioner has a
‘HEAT PUMP”.
From the time you turn the thermostat on, there is a delay built into
the furnace to perform a purge cycle preventing any possible
propane vapor build-up in the chamber.
NOTE:
Different model furnaces are used for different unit floor
plans. Each model furnace has it’s own Users Manual. The following
instructions may vary slightly from the instructions in your unit.
Therefore it’s very important that you refer to the Users manual
provided in your unit.
Operating Instructions
1. Before using your furnace, it is suggested to open entrance door
and windows to air out camper for any unusual odors such as
propane or other.
2. Be sure propane container has fuel and valve is open.
3. Release thermostat from “OFF” position and onto “HEAT”
position.
4. Set temperature 5 to 8 degrees above room temperature.
5. Blower will start in 0 to 15 seconds, run for 30 seconds during
heat chamber “PURGE” cycle, removing propane vapor, if any.
6. Second cycle, blower continues to run, module board will: (a)
Send spark to burner tube, (b) Open valve in control to release
propane to burner tube.
7. Ignition attempt will be for 7 seconds.
8. Failing to ignite, board will make 2 more attempts to light and
then go to lockout.
9. If after (3) attempts with no ignition, drop thermostat to lowest
setting, wait 1 minute and repeat steps 4 to 7.
10. After burner tube lights, set thermostat to desired setting.
11. To shut burner down, move thermostat to lowest setting or
“OFF”
12. Blower will continue to run for about 2 minutes until heat is
removed from chamber.
PDF created with pdfFactory trial version www.pdffactory.com