KZ RV SPORTSMEN, Руководство пользователя

Страница: 66 / 101

59
1. Main pass thru portion to fill container and draw propane out is
controlled by upper 3-sided knob on top.
2. A small screw on the side of main body referred to as the 10 %
valve which allows air to be released and indicates when container
is filled to 80% capacity.
3. Incoming positive seal valve MUST be pushed inward with fill
nozzle or by POL fitting to draw vapor out for appliance use.
On the bottom/inside of container is the float which closes when
80% of capacity has been reached. This permits expansion space in
tank when temperature rises. See section on main hoses.
At any point a container is disconnected, BE SURE to install the
“dust cap” over valve entry (if so equipped)
Whenever the container is detached from the propane system, DO
NOT allow the cylinder to move or roll around during transportation
to and from the gas supplier.
Servicing and Filling Propane Containers
Filling a propane container must be done carefully and correctly.
Only a qualified person, properly trained on inspection, filling and
safety procedures, should fill containers with propane only.
To remove the propane containers for refilling.
1. Remove the bottle covers ( if used ).
2. Close the main valve on the container.
3. Remove the two hoses at the ACME connection.
4. Install the rubber cap over the valve ACME connection.
5. Remove/loosen the wing nut holding the clamp hook.
6. Remove the clamp hook.
7. Fill the bottle and reverse the procedure to install. Test all
connections for leakage.
A new container MUST be “purged” before placing into service and
MUST NEVER BE OVERFILLED. Purging is an operation performed
Your vehicle has exterior combustion air inlets. Appliance pilot lights should be turned off
during gasoline or propane refueling. (Required by law in some states.)
WARNING
!
PDF created with pdfFactory trial version www.pdffactory.com