Multi-Image Splicing Processor
12
Note:
Mode 1 is default startup data of device boot; it’s suggested that the most
common mode should be saved to Mode 1 and the device can save 32 kinds of mode
at most.
For above operation which has fulfilled the first requirement of the program,
namely splicing of the whole screen, image is displayed completely and correct data
are saved. For the second requirement which is that screen is divided into three parts
with proportion of 1:2:1, only further setting on operation above is needed.
Step 5:
Click “MENU” and enter into main menu interface and select “Image
layout” then Layout 3.
Note:
Default layout of the device is three equal parts. If it is desired, there is no
need to carry out step 6. If not, following operations are required.
Step 6:
Click “OK” to return to main menu interface and select “Image
parameter” to enter into its setting interface. Since required image proportion is 1:2:1,
the size of image 1, namely the left one is 1720×576, image 2 which is the middle one
is 3440×576 and image 3, the right one, is 1720×576. Since image 1 starts from the
left, its horizontal position is 0. In the same way, image 2 is 1720 and image 3 is
1720+3440=5160. Due to the reason that vertical position is calculated from the top,
vertical position of three images are all 0. Above all, image 1’s horizontal position is 0,
vertical position is 0, horizontal size is 1720 and vertical size is 576; the four
parameters of image 2 are 1720, 0, 3440 and 576 respectively and those of image 3
are 5160, 0, 1720 and 576. After inputting, just click “OK”.
Image Parameter
Image 1
S
elect by Finger key
Image 2
×
1
×
10
×
100
Image 3
Rotate knob to select output
Click
“
OK
”
to adjust
Vertical Size: 1080
Vertical Position: 0
Horizontal Size: 1920
Horizontal Position: 0
