9
2. CONTROLS AND INDICATORS
2-1. FRONT
(1) [DC IN] connector
Used for connecting the optional AC adapter.
(2) LED
Lights up or blinks when connecting the PC, when communicating with the PC.
For details, see table 2-1.
(3) [USB] connector
USB interface connector
Used for connecting the PC.
(4) GND terminal
GND terminal
3 Be sure to connect the GND terminal to the ground.
Table 2-1 LED and operations
Status
Operation
Green
Light up
After starting up the Dynamic Data Recording Software DCS-100A.
Blink
When the EDX-10B is communicating with the PC.
Lights out
The Dynamic Data Recording Software DCS-100A is not working.
Red
Blink
Under the following conditions. When the LED lights up in red, stop using the
EDX-10B and disconnect the USB cable after disconnecting the optional AC
adapter.
When the number of connected units exceeds the number of connectable units.
*The number of connectable units is refer to 3-2-1.NUMBER OF
CONNECTABLE MEASURING UNITS.
When connecting 5 or more measuring units.
Voltage range of the optional AC adapter exceeds 4.5 to 5.5 V.
Voltage range of the USB bus power exceeds 4.5 to 5.5 V.
When an error occurs in the EDX-10B or in measuring units.
When detecting the overcurrent on the USB cable.
2-2. SIDE
(5) Fixing screw hole
For fixing the EDX-10B and measuring unit by using a screw.
(6) Finger slot
For connecting/disconnecting the EDX-10B and a measuring unit.
(7) Rubber foot slot
The EDX-10B has small rubber feet (optional) to keep it from sliding around
when placed on a flat surface.
(1)
(2)
(3)
(4)
(5)
(7)
(6)
