１
10
１
1.
Connect the power plug to a power supply.
2.
Turn the knob counter-clockwise until it stops to release the pressure to
the tube. Then s
witch on the circulation pump
and run for a few minutes
to
let the simulated blood fill the tub
ing
.
Training
Training
Training
1. Discharge the simulated blood from the system.
Discharge the simulated blood
Discharge the simulated blood
After training
Excessive force may cause the knob to break. Please handle it with care.
Be careful so that the end of the tube is always inside the jar wall.
suction tube
3. Strength of the pulses can be adjusted by turning the
adjustment knob on the simulator base.
To make the pulse stronger,
turn the knob clockwise.
4. If the strength of the pulse does not increase with the knob adjustments, replace the artery tube
with a new tube. Do not turn the knob with excessive force.
Lift the suction tube so that the end of the tube comes
above the fluid surface and run the circulation pump
until all the fluid in the tubes
has drained
out into the
jar.
2.
Replace the jar of the simulated blood with a jar of clear water. Put the tips of suction
and discharge tubes into the water and run the circulation pump until the inside of the tubes are
cleaned.
3.
Discharge the water from the simulator following the procedure of discharging simulated blood.
4.
When the hand-wrist model is stained
,
quickly wipe it off with cloth or wash the model with water.
Caution
Caution
strong
weak