３
8
①
Set the silicon tape on the radius base.
Setting up the wrist model and
puncture unit
Setting up the wrist model and puncture unit
②
Set the artery tube
The silicon tape is replaceable.
Silicon tape
Knot
Radius
base
1. Insert one end of the silicon tape to one of the slits on
the radius base edge so that the tape is anchored by
the knot.
2. Pulling the silicon tape, place it in the gutter on the
base and fix it by inserting the other end into the slit
on the opposite side. Make sure not to twist the tape.
3. Put the radius base with the silicon tape to the
simulator base, noting that the tape and notch on
the simulator base are aligned.
1. Connect the white connecter at the end of artery tube
to the white socket on the simulator base.
2. Lock each connection by turning the socket clockwise
until it clicks.
If the lock is incomplete, the tube may come off
and simulated blood may leak.
Preparation
Attention
Attention
Note: The needle holes on the brand new artery tubes are
intentionally made to control pressure, and not a product
defect.
To be
aligned