9
How to use the nailer
Loading/unloading fasteners
Point the nozzle away from persons and keep your
finger out of the trigger when loading the fasteners.
The fastener is mounted with 1 of 3 different methods
of loading.
1: If the nailer has a “2-step” magazine, slide the nail
strip into the magazine until the nail strip has passed
the nail stopper.
Pull the pusher until it is beyond the stopper.
Release the pusher to engage the nail strip and feed it
into the nozzle.
To unload the fasteners from the magazine, press the
release lever on the pusher and tilt the tool to slide the
nail strip to the rear end of the magazine. Press the nail
stopper and slide out the strip.
2: If the nailer has a “3-step” magazine, follow the same
safety precautions and continue with the following
steps:
To load the nail, pull the pusher to the rear until it is
locked to the magazine at rear position.
Slide nail strip into the magazine. Release the pusher to
push the fasteners into the nozzle.
To unload the fasteners from the tool, pull the pusher
to rear locking position. Slide the fasteners out of the
magazine.
3: If the nailer is loaded from the side, follow the same
safety precautions and continue with the following
steps:
Activate the button below the air supply nipple, and the
magazine cover can be pulled backwards. Load the fas
-
tener into the magazine, and close the magazine cover.
To unload the fastener, activate the button below the
air supply nipple, pull back the magazine cover, and
remove the fasteners.
Depth of drive adjustment
It is possible to adjust the depth of drive on this nailer.
If the nailer has an adjustable screw placed under the
trigger, it can be turned towards deeper or higher.
Remember to disconnect the air supply before adjust
-
ing.
If the nailer does not have an adjustment screw, it may
be possible to adjust the depth by loosening the screws
in front of the nozzle.
Deeper drive: Loosen the screw on front of the nozzle,
move the nozzle upwards, and tighten the screw again.
Reduced drive: Loosen the screw on front of the nozzle,
move the nozzle downwards and tighten the screw
again.
When the depth is adjusted, shoot a fastener into the
workpiece to determine if further adjustment is neces
-
sary.
Actuate method
The nailers can be fitted with different actuate methods.
Single sequential trigger
To actuate the nailer, depress the safety bracket against
the workpiece, and pull the trigger.
To actuate the nailer again, you will need to release
the safety bracket fully and release the trigger before
repeating the above procedure.
Bump fire trigger is available as spare part.
The trigger can be fitted with a quick-changer. This
allows you to switch between single sequential fire (T)
and bump fire (TTT).
To change the fire mode, push the red button outwards
and turn it to the desired position.
Bump fire
Get a good grip on the tool’s handle. Activate the trig
-
ger, bump the safety bracket against the workpiece,
and a shot will be fired. Each time the safety bracket is
bumped into the workpiece, the nailer will fire.
When the work is done, release the trigger to avoid
misfire. Keep your finger off the trigger when carrying
the nailer.
NB: Bump fire must not be used when working on a
scaffold, stairs, ladders, or if the user is moving around.
English
Содержание TJEP finish
Страница 2: ...2 www tjep eu ...