Kyocera FS-680, Руководство пользователя

Страница: 22 / 141

Chapter 1 Installing the Page Printer
1- 3
·
Level and well supported
Place the printer on a sturdy table or desk. Do not place the printer on an unstable cart, stand, or
table. The printer may fall, causing injury, or serious damage to the printer.
·
Near an AC wall outlet, preferably one that can be used for the printer alone (see section
Power Supply on next page.)
·
Only use this printer under the voltage listed on the serial number label attached to the rear
panel of the printer.
Power requirements are:
Voltage 120 V (U.S.A.), 230 V (European countries, Australia)
±10% at each voltage
Frequency 60 Hz (120 V), ±2%
50/60 Hz (230 V), ±2%
Current capacity Max. 4.3 A at 120 V, or Max. 2.1 A at 230 V
The outlet should be earthed, or an adapter should be used.
If an extension cord is used, the total length of the power cord plus extension should be 5 meters
(17 feet) or less.
·
Well ventilated, not too hot or cold, and too damp or dry
Temperature 10°C to 32.5°C, ideally about 23°C (50°F to 90.5°F, ideally about 73.4°F)
Humidity 20% to 80%, ideally 65%
If you install the printer where the temperature or humidity is outside the above ranges, you may not
get the best print quality, and there will be an increased chance of paper jams.