Kyocera Ecosys FS-6700, Руководство по обслуживанию

Страница: 16 / 167

A-5
FS-6700
Data error information (Snn)
A data error occurred on the serial interface is indicated on the service status page.
The Snn code in the same row as Service information on the status page shows var-
ious error conditions as follows:
Changing the serial interface configuration
To change the serial interface protocol from RS-232C to RS-422A, or vice versa, the
main controller board must be taken out of the printer. Protect the electronics by
taking these precautions:
Caution Before touching the main circuit board, touch a water pipe or other
large metal object to discharge yourself of static electricity. While
doing the work, it is recommended that you wear an antistatic wrist
strap.
Caution Touch the main circuit board only by the edge.
Caution Be sure to remove the memory card first if inserted in the printer’s
memory card slot.
Refer to chapter 3 and remove the main circuit board out of the printer.
Locate the jumper connector.
To change the serial protocol from RS-232C to RS-422A, for example, carefully
remove the jumper connector from the main circuit board, and reconnect to the pin
position shown in the diagram.
†††.Robust: Xon is sent every 3 to 5 seconds during ready or waiting. Error Control: Sets the printer
off line when an error occurs or at off line state.
Table A. 4 Data errors
S code Meaning
S00 No error
S01 Framing error
S02 Overrun error
S03 Overrun error and framing error
S04 Parity error
S05 Parity error and framing error
S06 Parity error and overrun error
S07 Parity error, overrun error, and framing error