12
Printer Configuration
The currently registered IP address, Subnet Mask and Gateway address will all be
displayed. To change an address, press the appropriate “CHECK” key to display
the corresponding setting screen.
* To change the network management code, proceed to step 6.
The address will be separated into four blocks – each consisting of three numbers.
Press on the block to be changed and then use the numeric keys to enter the
desired number. If the entered numbers are correct, press the “ENTER #” key.
Once the complete address is entered as desired, press the “END” key.
* The illustration on the right shows the screen used for entering the IP address.
Make sure that “OFF LINE” is shown in the message display (the printer is
currently off-line) and press the “SPECIAL” key. The printer setting screen will
appear.
Press the “NETWORK SETTING” key.
The ID code screen will appear.
Use the numeric keys to enter “4000” (the network management code).
* If the correct code is entered, the network setting screen will appear.
* This 4-digit code can be changed by carrying out the following procedure.
11
22
33
44
55