Throttle Lever
Control engine RPM with the position
of the throttle lever. Operate this lever
with the thumb. Pushing it forward
increases engine RPM and allowing it
to retract decreases engine RPM.
Throttle Limiter Screw
58
Use the headlight HI/LO switch to
select the high or low headlight beam
when the ignition switch is in the
LIGHTS position. When the switch is
in the HI position, the high beam will
illuminate. When the switch is in the
LO position, the low beam will illumi-
nate.
Emergency Stop Switch
OFF position - The ignition circuit is
off. The engine cannot be started or
will not run. If the emergency stop
switch is used to stop engine without
turning off ignition switch, the battery
may discharge.
RUN position - The ignition circuit is
on. The engine can start and run.
Starter Button
Pushing in on this button activates the
starter motor. Before starting the
engine, make sure the ignition switch is
in the ON position, the transmission is
in neutral, and the brake lever lock is
engaged.
NOTE: This ATV has safety inter-
lock switches which prevent the
starter motor from activating when
the transmission is not in neutral.
ATV-0053
Throttle lever travel may be limited by
adjusting the throttle limiter screw. The
throttle limiter should be adjusted
according to the operator's skill and
experience. To adjust the throttle lim-
iter, use the following procedure.
1.Loosen the jam nut.
Turn the throttle limiter screw
clockwise to decrease engine RPM
maximum or counterclockwise to
increase engine RPM maximum.
2.
3.Tighten the jam nut securely.
NOTE: The ATV is equipped with
a CDI unit that retards ignition tim-
ing when maximum RPM is
approached. When the RPM lim-
iter is activated, it could be misin-
terpreted as a high-speed misfire.
CF246A
Throttle Lever
Limit Screw
Jam Nut
Turn Signal Switch
Move to (L) to signal a left turn, (R)
to signal a right turn. Press to turn signal
off.
CAUTION
The turn signal light will not be
released automatically. Be sure to
reset it after using, otherwise it may
affect the traffic safety.