3 / 4
Perform the door handing process
Note: Turnpiece
may not rotate
smoothly until
after step 6.
or
A
B
C
status LED
Door handing process
was successful! Proceed
to next step after latch
bolt stops moving.
Remove battery
pack, wait 15 seconds,
then attempt the
process again.
This step will teach the lock the orientation of your door and is crucial for lock operation.
Make sure the door is open. Insert the battery pack
while pressing and holding the Program button.
Keep holding the button for 3-5 seconds after the
battery pack is inserted, then release the button.
The Status LED will flash red and green, and the lock
will beep. Press and release the Program button again.
The latch bolt will retract and extend on its own.
Did the latch bolt retract and
extend on its own?
YES
NO
turnpiece
shaft
torque
blade
H
U
(2x)
a
b
Press
and hold
Hold 3-5
seconds
Release
button
Press and
release
Re-key the lock (if needed).
Install the battery cover.
A
B
IMPORTANT: Remove battery
pack before re-keying.
Push turnpiece shaft onto torque blade.
A
Secure interior assembly with supplied screws.
B
G
G
F
K
V
(3x)
a
b
c
Re-key the lock to work with your
existing key. See the supplied
SmartKey Re-key instructions
for more information.
Reinstall battery pack.
Re-key the lock (if needed) and install the battery cover
Install interior assembly
5
6
7