kWiet Power dgw400dm, Руководство владельца и оператора

Страница: 23 / 40

- 20 -
8. Welding Operation
1) Push the emergency stop switch to stop engine in an emergency case.
<Note>
•
Be sure to return the engine starter switch to "STOP" after the engine stops.
•
Never hit the emergency stop switch by any tool such as a hammer.
•
Never use the emergency stop switch except an emergency case.
•
Turn the fuel lever to CLOSE to stop in the case the emergency stop switch does
not function.
2) Turn the emergency stop switch to arrow mark (clockwise) to release the
feature.
<Note>
•
Be sure to re-start the engine after releasing the emergency stop feature.
The engine does not start again though the starter motor is running, without
releasing the emergency stop feature.
8-1. Selection – Welding Cable
Select the cable with proper gauge, based on the allowable amperage and the
length, per the table shown below.
The welding capacity is to reduce if the small gauge cable is used.
<Note>
•
Welding cables should be used unstrained. When the welding cables are used in
swirl, the welding capacity is to reduce.
Size of Cable (Unit: mm
2
)
Return Length
Weld Current
20m 30m 40m 60m 80m 100m
400A 38 50 60 100 125 200
350A 30 50 60 80 125 150
300A 30 38 50 80 100 125
250A 22 30 38 60 80 100
200A 22 30 30 50 60 80
150A 22 22 22 38 50 60
100A 22 22 22 30 30 38
STARTER SWITCH
EMERGENCY STOP SWITCH