KVM-TEC Ultraline UVX1, Инструкция по эксплуатации, Страница: 17 / 37

kvm-tec | 17
2. installation of the extender
2.4 START uP
To start up the system without switch:
1. Make sure that the two monitors and the computer are switched on.
2. If you are using a Network Switch, connect the power cable to an earthed wall socket.
3. Connect both extender
power cables ( 6 / 20 ) to an earthed wall socket. Both extenders
will start an initialisation process. The red status LED blinks a few seconds. After a few
seconds the status LED lights green. The monitor will displays your computer’s desktop or
any open applications.
2.5 REPLACING ThE SFP MODuLE
The UVX1-F is delivered with a multimode SFP module.
To replace an SFP module with a different SFP+ module:
1. Remove the black dust protector from the SFP+ module.
2. Pull the metal latch of the SFP+ module forwards until it is at a right angle.
3. Replace the SFP+ module with the other module. Put the metal latch back in position. Only
use SFP+ modules from kvm-tec, or recommended by kvm-tec.
2