KVM-TEC Ultraline UVX1, Инструкция по эксплуатации, Страница: 15 / 37

kvm-tec | 15
2. installation of the extender
To install the product with/without Network Switch:
1. Position the uVX1/local unit/CPu (A) close to the host computer.
2. Position the uVX1/remote unit/CON (B) at the desired location.
3. If you are using a Network Switch, position the device between the uVX1/local unit/CPu
and the uVX1/remote/CON/ unit . Note: the maximum distance between the UVX1 units
with CAT7cable is 100 meter (328 ft) . The maximum distance between the UVX1-F extenders
with fibre cable in the single mode is 20 kilometer ( 12.42 miles) , with multimode is
300 meter (984 ft) - Standard
4. Connect a monitor to the DP-out (7) on the uVX1/local/CPuunit (A) - If a local Monitor is
required ( optional)
5. Connect one end of the supplied
DP-cable (D) to the DP-in (1) on the uVX1/local unit (A).
6. Connect the other end of the supplied DP-cable (D) to the DP connection on your
computer.
7. Connect one end of the supplied uSB cable (E) to the uSB connection (5) on the
uVX1/local unit (A).
8. Connect the other end of the supplied uSB cable (E) to a USB port on your computer.
9. Connect a monitor to the DP-out (14) on the uVX1/remote /CON unit (B).
10. Connect a keyboard to a uSB port (11) on the uVX1/remote/CON unit (B).
11. Connect a mouse to a uSB port (11) on the uVX1/remote/CON unit (B)
12. Do one of the following, depending on your model and configuration:
• For the UVX1 with Network Switch (see chapter Requirements for cable requirements):
• Connect one end of a CAT7 cable (not included) to the kvm-link port (4) on the
uVX1/local unit (A). Make sure that the plug is latched.
• Connect the other end of the CAT7 cable to one of the two CATx ports on the
Network Switch ( 10 G)
• Connect the end of a second CATx cable (not included) to the kvm-link port (4) on
the uVX1/remote unit (A). Make sure that the plug is latched.
• Connect the other end of the second CAT7 cable to the other CATx port on the
Network Switch ( 10 G)
• For the UVX1 without Network Switch (see chapter Requirements for cable requirements):
• Make sure the dust protectors on the Network Switch and Extenders have been
removed.
• Connect one end of the CAT7 cable (not included) to the kvm-link port (7 /21) on the
uVX1/local unit (A). Make sure that the plug is latched.
• Connect the other end of the CAT7 cable to the kvm-link port (4) on
the uVX1/remote unit (A) . Make sure that the plug is latched.
2