KVH Industries tracvision tv8, Руководство по установке

Страница: 48 / 51

47
Route and Secure the Cables
a. Remove the four M4 screws securing the
cable brackets to the inside rim of the
baseplate (see Figure 76). Remove and save
the cable brackets.
b. Route the RF cable(s) belowdecks through the
cable access hole in the mounting surface.
Leave an adequate service loop,
approximately 8" (20 cm) of slack, in the
cables for easy serviceability. Later, you will
connect the RF1 cable to the TV-Hub and
other RF cable(s) to the receiver(s).
c. Route the antenna end(s) of the RF cable(s)
through the baseplate’s bottom cable entry
hole. Using a 7/16" wrench, connect the
cables to the connector panel (see Figure 77).
If you need to connect only one RF cable,
connect the cable to the RF1 connector.
Connect any additional RF cables to the RF2,
RF3, and RF4 connectors. See Figure 10 on
page 9 to determine the number of RF cables
required.
NOTE: If you connect two or more RF cables, label
both ends of each cable to match the connector. This
will make it easier to identify the cables later.
Figure 76: Cable Brackets on Inside Rim of Baseplate
M4 Screw (x4)
Figure 77: Cable Connections on PCB
RF2
RF4
RF1
RF3
Be sure to properly align the RF1 cable with
the panel connector before tightening.
Connecting the cable at an angle may damage
the cable’s center tines.
IMPORTANT!
Continued
Using the Bottom Cable Entry Kit
C