2-1
Installation
54-0149 Rev. B
2
Installation
2.1
Overview of Installation
TracVision SA is designed for simple installation and setup. Just
follow these easy steps:
1. Choose the antenna location.
2. Mount the antenna unit.
3. Connect the antenna unit cables.
4. Connect the antenna unit to the TV IRD.
5. Connect the TV IRD to the TV.
2.1.1 Installation Tools and Materials Required
•
Electric drill
•
3
⁄
16
”-drill bit and
1
⁄
2
” hole saw
•
1
⁄
2
”-socket wrench
•
#2 Phillips and #0 flat tip screwdrivers
•
Augat Snap ‘n Seal Crimp/Strip Tool (Part
Number IT1000) if using the KVH-provided
F-connector
•
Silicone sealant or RTV
•
Thread locker (as required)
•
7
⁄
16
”-open end wrench
•
Wire strippers
•
Adhesive suitable for specific roof construction
and materials (e.g., butyl rubber adhesive tape or
other liquid adhesive)
•
Rivet Gun and
3
⁄
16
”-rivets (or other fastener suitable
for specific roof construction)
•
Terminal crimp tool
•
Optional PC with terminal emulation software
such as PROCOMM, Windows Terminal, or
Windows 95 Hyperterminal
Plan the entire installation before
proceeding! Take into account
component placement, running
cable distances between units, and
accessibility to the equipment after
installation.
The product serial number may be
found in front of the antenna
reflector on the rotating plate as
well as on the inside front cover of
this manual.
While some DIRECTV IRDs
offer on-screen messages, it is
recommended that a PC be
available for all installations of
both DIRECTV and EchoStar.
