2-4
A Guide to TracVision Cruiser
4. Position the stiffening plate in the desired
location on the centerline of the vessel. The
dimensions of the stiffening plate are illustrated
in Figure 2-3.
5. Note that the cables exit the antenna unit at the
wide end of the stiffening plate. The proper
orientation is illustrated in Figure 2-4. While the
stiffening plate is in place, mark location(s) on
the deck to permit convenient cable access to the
liquid-tight fittings on the back of the baseplate.
6. Using the stiffening plate as a template, lay
out the locations of the six mounting holes (also
pictured in Figure 2-4). Drill six
3
⁄
8
" (10mm)
mounting holes in the installation surface.
Apply a bead of silicone sealant around each
hole.
7. Drill cable access hole(s) in the vessel as needed.
Figure 2-4
Orientation of the Antenna Unit
and Stiffening Plate
26"
21.11"
4.73"
4.0"
19.277"
1.565"
24.0"
1.18"
Figure 2-3
Stiffening Plate Dimensions
