KVH Industries TracVision A7, Руководство по установке

Страница: 17 / 48

54-0350
2.6
TracVision A7 Installation Guide
5. With the cushions installed in the brackets, the
bottom of the antenna should rest above the
vehicle’s roof. If the antenna’s base touches the
roof, you will need to add a spacer under each
bracket to raise the antenna higher off the
crossbars.
If spacers are needed, follow Steps a and b on this
page to install a spacer under each bracket.
a. Remove the #8-32 x
3
⁄
8
" screws and washers
securing the factory-installed plastic spacer to
the metal bracket.
b. Insert a second spacer from the kitpack
between the original spacer (which holds the
rubber cushions) and the bracket. Secure both
spacers to the bracket using the #8-32 x 7 ⁄
8
"
screws supplied in the kitpack and the
original washers that you removed in Step a.
Vehicle Roof
Crossbar
Using Spacers to Raise the Antenna Above the Roof
Vehicle Roof
New Spacer
Gap Crossbar
Bracket
New Spacer
Flat Washer
Lock Washer
#8-32 Screw
Factory-installed
Spacer
Adding a Second Spacer to the Bracket (If Needed)
Without Spacer
Antenna Touching Roof
With Spacer
Gap Between Antenna and Roof