SECTION 8 - INFLUENCES AND INTERFERENCE
8.3
displayed as targets. However, if the RFI signals are
strong enough, the Falcon HR will detect these sources
of interference, the TARGET window will display “rFi”
and all speed-readings will be blanked, except for
locked speeds, until the source of interference is
reduced or eliminated.
6. Heater and A/C fan motors can cause a radar unit to
display the fan’s speed, rather than a weaker target
vehicle’s speed. A trained operator should not be
confused by intermittent fan readings and the distorted
audio. Proper antenna mounting, placement, and
aiming will eliminate most of the potential fan
interferences.
NOTE:
If there are still problems with fan interference
in your type of patrol vehicle, Kustom Signals
can provide antenna noise reduction pads to
prevent the fan signal from reaching the
antennas. Contact your District Sales Manager
or Kustom Signals' Customer Service
department for antenna pad options.
7. Vehicle ignition interference, See Sec. 3.2 for further
details.
NOTE:
Refer to the National Highway Traffic Safety
Administration’s Basic Training Program in
RADAR Speed Measurement for further information
on interferences and training guides.
Содержание Falcon HR
Страница 2: ......
Страница 93: ...SECTION B ATTESTATION OF CONFORMITY B 1 B ATTESTATION OF CONFORMITY B 1 CE CERTIFICATION OF CONFORMITY...
Страница 94: ...SECTION B ATTESTATION OF CONFORMITY B 2 B 2 AS NZ CERTIFICATION OF CONFORMITY...
Страница 97: ......