43
3BA00205 • 2020-10-28 • Rev. 5
Ersa i-CON
VARIO 2
Functional description
6.8
Changing a heating element
Before changing a heating element:
■
Switch off
the
station and allow the soldering tip to cool down. Then remove the
soldering tip as described above.
ATTENTION! Risk of burning!
Allow the unit to cool to a safe temperature.
6.8.1
Changing the i‑TOOL heating element
■
Attach the forceps tool between handle
①
and thread
②.
■
Loosen the heating element by slightly jacking movements.
■
Pull out the loosened heating element.
■
Push the new heating element into the handle.
Please make sure that the groove
①
in the heating element matches the pin
②
in the
handle.
■
Push the heating element firmly into the handle.
6.8.2
Changing the i‑TOOL AIR S heating element
■
Please return the tool to the Ersa Service to have the heating element replaced.
6.8.3
Changing the CHIP TOOL heating element
■
To change the heating element please proceed as described in the operating
instructions of “Ersa CHIP TOOL” (3BA00128‑00).