15
3BA00205 • 2020-10-28 • Rev. 5
Ersa i-CON
VARIO 2
Commissioning
5.3
Switching on the first time
For safe and durable operation of the soldering tools you must strictly observe the following items:
■
Before switching on, make sure that the mains voltage complies with
the value specified on the type plate.
■
Switch off the soldering station by the mains switch.
■
Check the correct fit of the soldering tip.
■
Connect the soldering tool with the station
❶
and store it in the
holder.
• Tool
socket A1: electrical power supply, 150 W maximum
• Tool socket VAC: Vacuum supply (only with models with desoldering iron or with
vacuum pump)
•
Tool socket A2: electrical power supply, 200 W maximum
• Tool socket Air: Air supply
The table below contains information of which tools can be operated on which tool
sockets. Tools requiring vacuum supply must be connected parallel to the tool sockets
A1 and Vac. Tools requiring air supply must be connected parallel to the tool sockets A2
and Air.
Soldering tool / station
i‑CON VARIO 2
i‑CON VARIO 2 P
i‑CON VARIO 2 HP
i-TOOL
A1
A1
A1
i-TOOL AIR S
A2 / AIR
A2 / AIR
-
X-TOOL VARIO*
-
A1 / VAC
-
CHIP TOOL
A1
A1
A1
CHIP TOOL VARIO
A1
A1
A1
i-TOOL HP
A2
A2
A2
TECH TOOL
A1
A1
A1
MICRO TOOL
A1
A1
A1
i-SET TOOL
A1
A1
A1
VAC PEN*
-
VAC
-
All tools that are not mentioned above are not recommended for the usage with this station.
* With vacuum pump version only
From the interface connection
A
(see p. 14, no.
⑪
) a hot plate or a fume extraction can be controlled.
With the Y-adapter 0IRHP100A-15 both devices can be controlled from the interface port
A
.
From the interface port
B
only a fume extraction can be controlled.
