Kurtz Ersa i-CON TRACE, Руководство по эксплуатации

Страница: 41 / 46

Service and maintenance
Fig. 25: Reset button [12] on the underside of the device
d) With the reset button pressed in, switch on the soldering station.
e) When all 3 LEDs light up yellow, release the reset button.
ð
The soldering station has been reset to factory settings.
f) Switch off the soldering station.
g) Reconnect the disconnected cable.
h) When using WLAN to connect to the network:
After a reset, the soldering station must be reintegrated into the WLAN. To do
so, use the Bluetooth function of the “Ersa TRACE” app on a mobile device.
Read more about this in Chapter Establishing a WLAN connection between the
soldering station and a network [
} 24].
7.2.4 Possible defects
The following errors indicating possible defects of the soldering station may occur.
– The soldering station shows permanently only the room temperature.
The heating element or the supply line to the soldering iron is defective.
The room temperature is also displayed when the soldering station has been
idle for a few minutes (Ready LED pulsing yellow).
Info: If the soldering station is sent in for repair, all accessory tools must be shipped
with it.
Ersa GmbH 3BA00252-01 | Rev. 1 41