Küppersbusch KD 674.1 GE, Инструкция по использованию и монтажу

Страница: 21 / 68

21
Part 1 - INSTALLATION INSTRUCTIONS
- Remove the plug from the upper part of
the ducting fan unit ( fig. 17 ), as it is not
possible to insert the flange F with the
plug in place.
- Fit the flange F Ø120 or 150 mm ( fig.
18 ), replace the plug.
· Air outlet directed to the right or left
hand side (fig. 4a-b).
- Remove the four screws fastening the
plastic frame, as shown in fig. 16 .
- Fit the ducting spigot R ( fig. 19 ) and replace
the four screws removed as above.
3 - Fixing the chimney
a) Loosen the screws M fixing the two parts
of the chimney and pull the inner section I ( fig. 20 )
almost all the way out. Remove the protective film P .
b) Rest the lower section of the chimney in its housing on
the top of the hood canopy. Lower the ducting fan unit
until it reaches the wall bracket
S and fix it using the
screw H provided ( fig. 21 ). Fit the cover D (provided)
on the wall bracket S ( fig. 22 ).
c) Insert gasket G1 (found in the accessory bag) on the
base of chimney stack A , so
that it adheres perfectly to the
shape of chimney stack
A . Then
fix chimney stack A to the hood
unit C using four of the screws
provided E ( fig. 23 ).
d) Insert the transparent seal Q
(provided), so as to eliminate
any play between the two parts
of the chimney (
fig. 24 ). Lock
the screws M .
e) Remove the support rod B .
1 7
1 7
1 8
1 8
2 0
2 0
1 9
1 9
E
E
E
E
A08_TL
A
G1
C
2 1
2 1
2 2
2 2
2 3
2 3
2 4
2 4