19
GB
FIXING THE FRAME
• Unfasten the two screws fastening the upper
chimney stack 2.1 to the frame, and remove the
chimney from the upper stack.
If you wish to adjust the height of the frame, proceed
as follows:
• Unfasten the four safety screws located at the
top in the frame separation area. (A)
• Unfasten the eight metric screws joining the two
columns, located at the sides of the frame. (B)
• Adjust the frame to the height required, then
replace all the screws removed as above.
• To guarantee greater stability in the frame, replace
the four safety screws in the last hole available.
• Insert the upper chimney stack from above, and
leave it running free on the frame.
• Lift the frame up, making sure that the index over
the frame plate is turned to the front.
• Fit the frame slots onto the two screws inserted
in the ceiling as above, and turn until reaching
the centre of the adjustment slot.
• Tighten the two screws and fasten the other two
screws provided; before locking the screws
completely, it is possible to adjust the frame by
turning it, making sure that the screws do not
come out of their housing in the adjustment slot.
• The Frame must be securely fastened so as to
support both the weight of the Hood and the stress caused by occasional axial pressure against the
fitted Appliance. After fixing, make sure that the base is stable even when the Frame is subjected to
lateral stress.
• If the Ceiling is not strong enough in the area where the hood is to be fixed, the Installer must
strengthen the area using suitable plates and counterplates anchored to resistant structures.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe using the pipe clamps 25 provided.
• Remove any activated charcoal filters.
9
ø
120
ø
150
A
B
2
1
1
2
