In this case, in order to make the setting for operating the lighting per sensor
key, you will need to touch the sensor key continuously for approx. 5 seconds
until bars appear in display 2 (Fig. A). The top bar (Fig. B) is for lighting the
LED glass panels and the bottom bar (Fig. C) is for lighting the lower LED
modules (to light up the working place). Pressing the
“+” or “-” keys will make a
setting for which light is to be switched on or off in future when the lighting key
is pressed.
The same method is used to make settings for lighting per No Touch
operation. To do so, hold your hand about 3-5 cm in front of this key for
approx. 5 seconds, until bars appear in display 2. The top bar (Fig. B) is for
lighting the LED glass panels and the bottom bar (Fig. C) is for lighting the
lower LED modules (to light up the working place). Pressing the
“+” or “-” keys
will make a setting for which light is to be switched on or off in future when the
lighting key is pressed.
Fig. A
Fig. B
Fig. C
Dimmer function
The display will show two horizontal bars as soon as the lighting symbol is
touched continuously for approx. 5 seconds. By pressing the
“+” and “-” keys,
you can initially determine for which lamp you wish to make dimmer settings.
In this case the top bar (Fig. B) is for lighting the LED glass panels and the
bottom bar (Fig. C) is for lighting the lower LED modules (to light up the
working place). Once you have decided on one of the two lamps (by pressing
the
“+” and “-” keys), press the lighting key once again and the display will
show the level of brightness. The lamp is pre-set at brightness level
“9” in the
factory. Touching the
“+” and “-” keys will set the brightness level of your
choice. Press the
“lamp” symbol once again to save this setting.
Important: Please note that it is not possible to set the dimmer function for
both lamps at the same time. You will always need to make these settings
individually for each lamp.
38
Содержание IKD9980.0BGE
Страница 2: ......